1 Reply by RobLarge

  • RobLarge
  • RobLarge
  • Veteran
  • Offline
  • From: Wiltshire
  • Registered: 15-07-2008
  • Posts: 812

Re: Related data bug

I have just started noticing a bug where I don't think there was one previously.

If I select a Location in the locations hierarchy and then view related names and addresses it takes me to the names and addresses page filtered to those individuals who appear in TENURE. This is as it should be, but if I then click the 'Show all' button it does not cancel the filtering and show all names. The show all  button does disappear however as it would if the filter had been removed.

I haven't observed this with any other of the possible Related data combinations but I haven't looked very hard.

Rob Large
Wildlife Sites Officer
Wiltshire & Swindon Biological Records Centre

RobLarge's Website

2 Reply by Eleanor Knott

  • Eleanor Knott
  • Veteran
  • Offline
  • Registered: 21-01-2009
  • Posts: 93

Re: Related data bug

Yes - it does that on ours as well.  However, it only seems to do this for the individuals part of the people database.  It works fine for the organisations part.  We don't have much people information attached to locations, so we'd not noticed this problem until you mentioned it.

However, I noticed that when a location has individuals and organisations attached to it, it only shows the indivuduals e.g. if it has Mr Smith (an individual) in the Tenure tab, and CWS Designation Panel (an organisation) in the Designation tab, it will only show Mr Smith.  If there is no-one in the Tenure tab it will show the organisations listed in the Designation tab.

Cheers
Ellie

Eleanor Knott
Devon Biodiversity Records Centre